Direct answer: Short answer: a drain that keeps clogging is not being cleared, it is being poked. Hair and grease coat the pipe wall, a cable opens a small hole, and the coating closes it again. Repeat clogs mean the cause, grease, roots, a belly or scale, needs naming.
The coating problem in kitchen and bath
Kitchen clogs in Madison are usually grease that went down warm and set on the wall in layers, narrowing the line a fraction each month. Bathroom clogs are hair bound with soap scum against rough old cast iron. In both cases the water slows gradually, gurgles, then one busy morning finishes the block. Clearing restores flow, but only jetting or a full cable pass restores the wall.
When the main line is the real story
If the lowest tub backs up when the washer drains, or several drains slow together, stop thinking about the sink. Roots at a clay joint, a belly holding water and solids, or a partial collapse are main line patterns common in Amqui and Madison Park. That is camera work: look, name it, then clear or repair the named thing instead of clearing the same mystery four times a year.
Habits that genuinely help
Grease belongs in a can in the trash, not the sink, even with hot water and soap chasing it, it sets further down where the line cools. Hair catchers in tub drains cost little and work. Wipes labeled flushable are the repeat offender we pull from Madison lines most, and they belong in the trash whatever the packet says.
Quick checklist
- Grease kept out of the kitchen drain
- Hair catcher fitted in tub drains
- Wipes in the trash, never flushed
- Camera look after the second repeat clog
Related reading and services
Helpful outside reading: Metro Nashville government services and Delta Faucet support.
